2通道隔离屏障，24 V直流电源（电源轨），热电偶，电阻式温度检测器，电位计或电压输入，可用作信号分离器（1个输入和2个输出），电流输出0/4 毫安 20；mA，汇点或源模式，可通过PACTware配置，线路故障（LFD）和传感器烧坏检测，最高SIL 2 acc；至；IEC；61508/IEC；61511

信号类型:模拟输入
安全完整性级别 (SIL):SIL 2
连接:终端14+、15或供电模块/电源导轨
额定电压:20 ...30 V DC
Ripple:在供应公差范围内
功耗:≤1.53 W
功耗:最大。1.53 W
Programming interface:programming socket
Connection side:field side
connection:terminals 1, 2, 3; 4, 5, 6
RTD:type Pt10, Pt50, Pt100, Pt500, Pt1000 (EN 60751: 1995)
type Pt10GOST, Pt50GOST, Pt500GOST, Pt500GOST (6651-94)
type Cu10, Cu50, Cu100 (P50353-92)
type Ni100 (P50353-92),Type Ni100 (DIN 43760)
Thermocouples:Type B, E, J, K, N, R, S, T (IEC N, S (IEC 1995)
type L (DIN 43710: (+), terminal 12: sink(-)
Output I, II:Analog current output
Deviation:Reaction time:worst case value (sensor shortage and/or sensor shortcircuit detection enabled)
mV: 1.2 s, Thermocouples with CJC: 1.4 s with fixed ref. temp: 1.4 s, 3-wire RTD: 1.1 s, 2-wire RTD: 920 ms, Potentiometer: 3-wire connection 2.8 s, 2-wire connection 2.25 s
Output/supply, programming input:Output/supply, programming input:The programming input and supply>
The programming cable provides galvanic isolation so that that ground loops are avoided ground loops.
LEDs:Configuration:Labeling:space for labeling at the front
electtromagnetic compatibility:61010-1:2004
环境温度:-20 ...60 °C (-4...140 °F)
保护程度:IP20
连接:螺丝端子
质量:约130克
尺寸:20 x 119 x 115 mm (0.8 x 4.7 x 4.5 inch) (W x H x D)，外壳类型 B2
安装:根据EN 60715:2001的35 mm DIN安装导轨上
欧盟类型检查证书:CESI 0